✿ little labelsmade for little joys
LET’S MEET YOUR PRINTER

A little sticker.
A little happiness.

First, let’s connect your B21S and make sure it prints beautifully from your iPhone.

YOUR FIRST TEST50 × 50 mm

SEZNIK sky blue · black ink · one sticker

The design tools come next. This first step checks Bluetooth printing and label placement.

Ready, set, sticker

Keep the printer nearby with the blue roll loaded. Close other apps connected to it.

  1. 1

    Connect your printer

    Choose your B21S. Connecting only reads its status.

  2. 2

    Check the connection

    Waiting for your printer.

  3. 3

    Print one gap-mode test

    This tests the accepted start sequence with gap sensing active. Prints one TEST; check its position before another print.

Check label alignment

Run one Start/Cancel check with gap mode active. No image is sent. The printer may briefly move paper.

Not connected

Your printer will only print after you press Print.

About this first test

Readable printing without RFID is confirmed over USB, Mac Bluetooth and iPhone Bluetooth on B21S hardware 40.10 / firmware 40.33. The photo shows vertical placement drift; alignment is being investigated. This trial briefly selects continuous mode to clear the rejection, then verifies gap mode before starting the image. It does not alter firmware or increase print density.

Keep Bluefy open while printing. If a job is interrupted, check the paper before choosing to print again. Reconnecting never reprints automatically.